Create, Write To, and Close an Indexed File

Now it's time to add the code that will create the indexed file, then write to it.

On the first line of the procedure division (that is, before the sections you have just added), paste the following code:
```
      *> Create an indexed file
      *>   open output an indexed file call "idxfile.dat"
           display "Create new indexed file"
           perform set-fcd
           move OP-OPEN-OUTPUT to opcode
           perform call-file-handler
           perform display-file-status.
```
This code performs the three sections that you coded in the previous steps. The operation code is set so that when call-file-handler is performed, the details in the FCD result in an indexed file, named idxfile.dat, is created.

Beneath the previous code, paste the following:

      *> Write 5 records increasing record length by 1 each time
           move all "A" to record-data
           move 0 to record-key
           move 5 to fcd-current-rec-len
           move OP-WRITE to opcode
           perform 5 times
              add 1 to record-key
              add 1 to fcd-current-rec-len
              perform call-file-handler
           end-perform.

This paragraph writes (using op-code OP-WRITE) five records to the open file.

Beneath the previous code, paste the following:
```
      *> Now close the file
           move OP-CLOSE to opcode
           perform call-file-handler
           perform display-file-status
           display "file closed".
```
Now the op-code changes to OP-CLOSE and the file is closed, and a file-status check is performed to confirm that the file has been closed successfully.

Now that you have created and populated an indexed file, the next steps demonstrate how to open it and update it.