The
SET command alters a condition code set by previous
MFJAMS commands in this job step.
Parameters:
MFJAMS supports the following parameters. They are supported as documented in the IBM documentation unless otherwise stated below:
- MAXCC=number
- Value that is to be set for the maximum condition code that was produced by all previous MFJAMS commands.
- LASTCC=number
- Value that is to be set for the last condition code that was produced by a
MFJAMS command.
Comments:
In both cases, the highest valid value is 16. If you specify a higher value, MFJAMS sets the condition code to 16.