GENERATE

Produce either a detail report or a summary report; test controls; generate control breaks; print totals, detail lines, headings, and footings; clear counters and accumulators; and, paginate the report.

Restriction: This topic applies only when the AppMaster Builder AddPack has been installed, and applies only to Windows platforms.

Syntax:

GENERATE dataname|reportname

Parameters:

`dataname`	Produce a detail report. Specify `dataname` in the TYPE clause as DETAIL.
`reportname`	Produce a summary report that contains no detail lines. Use `reportname` only if the referenced report group description contains a CONTROL clause, at least one REPORT HEADING, REPORT FOOTING, CONTROL HEADING, CONTROL FOOTING, or DETAIL group, and no more than one DETAIL report group

Comments:

On first GENERATE clause execution, AMB saves the control values. During other GENERATE executions, AMB tests these control values to determine control breaks until it detects one. When a control break occurs, AMB saves the new set of control values.
During report printing, AMB processes PAGE HEADING and PAGE FOOTING report groups for each page.
When the first GENERATE clause of a report executes, AMB processes, in order, the report groups defined in the report description-- REPORT HEADING, PAGE HEADING, and CONTROL HEADINGs, (from major to minor order).
When GENERATE dataname executes, AMB processes the designated report group. When GENERATE reportname executes, AMB performs certain steps to process a DETAIL report group.
When a GENERATE clause other than the first one executes, AMB locates control breaks. The rules for determining the equality of control data items are the same as for relation conditions. If a control break occurs
- CONTROL FOOTING, USE procedures and CONTROL FOOTING, SOURCE statements are able to access the control data item values.
- AMB processes the CONTROL FOOTING report groups in minor to major order. AMB does not process the CONTROL FOOTING report groups of a higher level than where the control break occurs.
- AMB processes the CONTROL HEADING report groups in major to minor order. AMB does not process the CONTROL HEADING report groups of a higher level than where the control break occurs.
GENERATE processing can only occur after INITIATE processing and before TERMINATE processing, for the report.